Types of flex PCB employed in communication base‑station equipment are differentiated by layer architecture, substrate composition, and copper foil configuration, each influencing cost structure and performance envelope. Single‑sided flex boards, comprising a solitary copper layer on a polyimide film, dominate low‑complexity feeder‑line modules and represent roughly 30 % of the type‑mix, owing to their minimal material expense and straightforward fabrication. Double‑sided variants introduce a second copper lamina, enabling signal routing and modest impedance control; they capture about 35 % of market volume, particularly in transceiver cards where board‑space efficiency is critical. Multi‑layer flex PCBs, ranging from three to eight layers, support dense routing, embedded passive components, and rigorous shielding, accounting for approximately 25 % of sales despite higher per‑unit cost. Rigid‑flex hybrids, which combine flexible sections with rigid FR‑4 islands, address mechanical‑stress zones such as connector interfaces and contribute near 7 % of the market. Finally, low‑loss substrates such as liquid‑crystal polymer (LCP) are niche but growing, representing the remaining 3 % and driven by 5G millimeter‑wave deployments. This taxonomy clarifies how material choices allocate revenue across the Communication Base Station Equipment Flex PCB market.